Mitigation of Power Quality Problems by using DSTATCOM with Fuzzy Based DQ Vector Control Algorithm

International Journal of Electrical and Electronics Engineering

© 2016 by SSRG - IJEEE Journal

Volume 3 Issue 10

Year of Publication : 2016

Authors : John De Britto C

10.14445/23488379/IJEEE-V3I10P102

How to Cite?

John De Britto C, "Mitigation of Power Quality Problems by using DSTATCOM with Fuzzy Based DQ Vector Control Algorithm," SSRG International Journal of Electrical and Electronics Engineering, vol. 3,  no. 10, pp. 7-11, 2016. Crossref, https://doi.org/10.14445/23488379/IJEEE-V3I10P102

Abstract:

This Paper presents the improving power quality by using three-phase distribution static compensator (DSTATCOM) with FUZZY logic based decoupled current controller algorithmis presented for compensation of loads in a distribution system. The DSTATCOM is most commonly used for harmonics elimination, load balancing and reactive power compensation with self-supporting dc bus in the distribution system. The DQ-based control algorithm is used for extraction of fundamental weighted values of these active and reactive power components of load currents in which are required for estimation of reference supply currents. It is most commonly based on a dq transformation system into control and balance the load voltage.

Keywords:

  It is most commonly based on a dq transformation system into control and balance the load voltage.

References:

[1]. Chattopadhyay, S., Mitra, M., Sengupta, S.: ‘Electric power quality’ (Springer Verlag, London, 2011)
[2]. 2Katsaprakakis, D.A., Christakis, D.G., Zervos, A., Voutsinas, S.: ‘A power-uality measure’, IEEE Trans. Power Deliv., 2008,23, (2), pp. 553–561
[3]. Zhang, G., Xu, W.: ‘Estimating harmonic distortion levels for systems with random-varying distributed
[4]. harmonic-producing loads’, IET Gener. Transm.Distrib., 2008,2, (6), pp. 847–855
[5]. Ahmed, E.E., Xu, W.: ‘Assessment of harmonic distortion level considering the interaction between distributed three-phase harmonic sources and power grid’, IET Gener. Transm.Distrib., 2007, 1, (3), pp.506–515
[6]. Song, Y., Wang, B.: ‘Survey on reliability of power electronic systems’, IEEE Trans. Power Electron., 2013, 28, (1), pp. 591–604
[7]. Karanki, S.B., Geddada, N., Mishra, M.K., Kumar, B.K.: ‘A DSTATCOM topology with reduced DC-Link voltage rating for load compensation with nonstiff source’, IEEE Trans. Power Electron., 2012, 27, (3), pp. 1201–1211
[8]. Mishra, M.K., Karthikeyan, K.: ‘A fast-acting DC-link voltage controller for three-phase DSTATCOM to compensate AC and DC loads’, IEEE Trans. Power Deliv., 2009, 24, (4), pp. 2291– 2299
[9]. ‘IEEE Recommended Practices and requirement for Harmonic Control on electric power System’, IEEE Std.519, 1992
[10]. Roy, S., Umanand, L.: ‘Magnetic arm-switch-based threephase series-shunt compensated quality AC power supply’, IET Electr.Power Appl., 2012, 6, (2), pp. 91–100
[11]. Sepulveda, C.A., Munoz, J.A., Esfuzzynoza, J.R., Figueroa, M.E., Melin, P.E.: ‘All-on-chip dq-frame based DSTATCOM control implementation in a low-cost FPGA’, IEEE Trans. Ind. Electron., 2013, 60, (2), pp. 659–669.
[12]. Salamah, A.M., Finney, S.J., Williams, B.W.: ‘Autonomous controller for improved dynamic performance of a.c. grid,parallelconnected.
[13]. single-phase inverters’, IET Gener. Transm.Distrib., 2008, 2,(2), pp. 209–218.
[14]. Ahn, H.-S., Chen, Y.Q., Moore, K.L.: ‘Iterative learning control: brief survey and categorization’, IEEE Trans. Syst.,ManCybernet. C, Appl. Rev., 2007, 37, (6), pp. 1099–1121.